Emerson MONITORING OpenComms Manuel D’Utilisation

A four-position DIP switch is provided, but no user configuration via 

DIP switches is necessary at this time.

Refer to Accessing the Configuration Port on page 7 for explicit 

details on accessing the service terminal / configuration port.
By default, the service terminal communication parameters are:

• 9600 bps
• No  parity
• 8 data bits
• 1 stop bit
• Flow Control: None

After connecting to the OpenComms NIC card, press the space bar or 

<Enter> key to activate the service terminal session. If no response is 

apparent and you have verified connectivity, cycle power on the Open-

Comms NIC and the service terminal sessions should appear automat-

ically.

 Cycling power on either the 7200 or the HiPulse UPS is not 

recommended unless the unit is in bypass mode. Consult the 

UPS user manual for further instructions.