Quantum Audio STT3401A Manuel D’Utilisation

Drive operation and maintenance 

Page 12 

Seagate Travan 40 Product Manual 

Before installing the Seagate Travan 40 drive make sure that the jumpers are 
properly configured for your system. Figure 6 shows the location of the jumper block, 
as well as master/slave jumper settings for various configurations. 

Note:  Record your jumper settings prior to installation. The jumpers are not visible 

after the drive has been installed. 

 

These jumper settings are explained in further detail below. 

• 

Jumpers 1 and 2 are reserved for factory use. Do not install a jumper on these 
pins. 

• 

Cable Select: When the CSEL jumper is off, the device address (Master or 
Slave) is determined by the setting of the "Master" jumper. When the CSEL 
jumper is on, the Master jumper is ignored and the device address is defined by 
the CSEL signal in the Host cable. If CSEL is tied to ground, the device address 
is Device 0 (Master). If the signal is tied high (or open), the device address is 
Device 1 (Slave). 

• 

Master/Slave: When this jumper is on, drive will act as Master on the ATA port. 
An ATAPI device cannot be a Master to an ATA device, only other ATAPI 
devices. If there is no jumper on the Master or CSEL jumper blocks, the drive is 
configured as a slave. See table below: 

Off 

On 

Device is Master (Device 0) 

Off 

Off 

Device is Slave (Device 1) 

On 

On or Off 

Device is Master or Slave depending 
on CSEL signal level