Quantum Audio STT3401A Manuel D’Utilisation

Drive operation and maintenance 

Page 14 

Seagate Travan 40 Product Manual 

6.   Secure the drive using the mounting screws. The threaded mounting brackets 

are designed for M3.0 metric screws. If you are mounting the drive in a 3.5-inch 
bay, use the screw supplied with the drive. Do not substitute other screws. Using 
longer screws may damage the drive. If slide rails are needed, use the plastic 
slide rails (supplied with the drive in some configurations). 

7.  Connect an available power cable to the power connector on the drive. Figure 6 

on page 12 shows the location of the power connector. The recommended 
power mating connector should have an AMP 1-48024-0 housing with AMP 
60617-1 pins or equivalent. 

Note:   Turn off all power before attaching power or interface connectors.  

8.  Connect the interface cable with the connector on the rear of the unit. When you 

make the connection, be sure pin 1 of the connector aligns with pin 1 on the 
cable connector. See Figure 6 on page 12 for the location of the connector and 
the Pin 1 location. 

Note:   Pin 1 on the connector on the rear of the drive is to your right as you look at 

the back of the drive (right side up). (See Figure 5.) Your cable should have 
Pin 1 highlighted by a color or dark strip. Be sure to mate Pin 1 on the cable 
to Pin 1 on the drive. Failure to do so could make the drive inoperative. Also, 
the cable is keyed to prevent incorrect installation. Make sure that the 
blocked pin in the cable connector coincides with the missing pin on the 
connector on the rear of the drive. (See Figure 6.) 

9.  Replace the computer cover. Be sure to reconnect any peripherals that you 

disconnected during the installation. 

10.  Plug the computer and any peripherals into an AC power outlet. 

11.  Start the computer and install your tape backup software. 

Figures 8 and 9, respectively, show the location of the mounting holes for the 
STT3401A and STT2401A.