Quantum Audio STT3401A Manuel D’Utilisation

Chapter 4 

Seagate Travan 40 Product Manual 

Page 13 

 

The STT3401A can be installed in a one-half-inch high by 3.5-inch form factor drive 
bay or in a one-inch high by 5.25-inch form factor (with mounting brackets). The 
drive can be installed in three different orientations: horizontally (LED to the left) and 
vertically (on either side).  

The following section provides directions for mounting the drive in either a 3.5-inch 
enclosure or in a 5.25-inch enclosure.  

1.  Before you install the drive, write down the serial number and model number 

shown on the drive and store this information in a safe place. You need this 
information if you ever call for service. 

2.  With the computer cover removed, remove the faceplate from the drive bay in 

which you plan to install the drive. Refer to the manual that you received with 
your computer for instructions about removing the computer's faceplate. 

Note:   If devices are installed in any drive bays adjacent to the one you are using 

for the internal drive, partially removing those devices might give you more 
working space. 

3.  Attach any special mounting hardware to the drive that your system might 

require. Refer to the manual that you received with your computer for 
requirements. 

4.  Locate the mounting screw holes in the drive brackets. Each side contains two 

sets of holes. Use the set that aligns the drive properly within the drive bay. 

5.  Slide the tape drive into the computer so that the drive bezel and the computer 

faceplate are flush. Figure 7 shows the screws used to mount the STT2401A in 
a 5.25-inch drive bay.