ADC SG-1 Manuel D’Utilisation
4-3
Parameter(s)
<slot number>\<port number>
The SCC and rear I/O interfaces have specific designations as shown in
.
Table 4-2. Interface Identification
<ipaddr>
The SCC IP address for interface in question. This address is set up to be on the same subnet as the Ethernet
network to which the SG-1 system is attached (format xxx.xxx.xxx.xxx).
network to which the SG-1 system is attached (format xxx.xxx.xxx.xxx).
<netmask>
The subnet mask associated with the SCC IP address. This address is based on the Ethernet network to which the
SG-1 system is attached (format xxx.xxx.xxx.xxx).
SG-1 system is attached (format xxx.xxx.xxx.xxx).
<mode>
Table 4-3. Ethernet Mode
Example(s)
Card/Type
Slot/Port 1
Slot/Port 2
Rear I/O
1/1
1/2
Gigabit Ethernet
1/1
1/2
ATM/GiG-E Card
ATM
2/1
2/2
GiG-E
1/1
1/2
Value
Explanation
10H
10M half-duplex
10F
10M full-duplex
100H
100M half-duplex
100F
100M full-duplex
1000H
1000M half-duplex
1000F
1000M full-duplex
Auto
Auto select mode
Host> configure terminal
Host(config)# interface ethernet 0 \ 2 12.3.66.211 255.255.255.0 auto mtu 1500
Added Item