RAD Data comm IPmux-16 Manuel D’Utilisation
IPmux-16 Installation and Operation Manual
Chapter 1 Introduction
Technical Specifications
1-17
T1
Framing
Framing
Compliance
Framing
Signaling
Framing
Signaling
ANSI T1.403
Passthrough, SF, ESF
CAS (bit robbing), CCS (transparent)
Passthrough, SF, ESF
CAS (bit robbing), CCS (transparent)
Local
Terminal
and
Terminal
and
Control
Interface
Interface
Mode
Baud Rate
Connector
RS-232 over RJ-45 (adapter cable to DB-15 supplied)
DTE
9.6, 19.2, 38.4, 57.6, 115.2 kbps
DB-9
DTE
9.6, 19.2, 38.4, 57.6, 115.2 kbps
DB-9
Dry
Contact
Contact
Alarm
Connector
Contacts
Contacts
DB-9
30V 2A
30V 2A
Ethernet
Modules
Modules
Compliance
Connector
Ports
Data Rate
Range
Connector
Ports
Data Rate
Range
IEEE 802.3, 802.3u, Ethernet, 802.1 p&q
RJ-45, 8 pin
1
10 Mbps or 100 Mbps, full or half duplex
Up to 100m over UTP Category 5 cables
RJ-45, 8 pin
1
10 Mbps or 100 Mbps, full or half duplex
Up to 100m over UTP Category 5 cables
General
System Indicators
General:
PS1
Green
ON when main power supply is
OK
OFF when malfunction is
OFF when malfunction is
detected, power does not exist or
power is off.
power is off.
PS2
Green
ON when secondary power
supply is OK
supply is OK
OFF when secondary power
supply does not exist (no power
supply redundancy) or when
supply redundancy) or when
power is off
RDY
Green
ON when self-test is successfully
completed
OFF during self-test
OFF during self-test
BLINKS when self-test fails
ALM
Red:
ON when a Minor alarm is
detected
OFF when no alarms are
OFF when no alarms are
detected