Carrier Access Access Navigator Manuel D’Utilisation

Commands such as ds0 <n:ch> require the operator to enter both the DS1 

and DS0 channel number or channel range. The DS1 and DS0 numbers are entered with 
a colon separating the numbers. For example, the channel list for DS1 #4 and DS0 channel 
#8 would be entered as ds0 4:8. The channel list may also contain a range of DS0 
channels. For example, DS1 #6 and DS0 channels #1 through #12 would be entered as 
ds0 6:1-12

. A colon follows the DS1 number, and the beginning and ending DS0 

channels are separated by a hyphen.

1. Show current DS0 settings with the following command:

show ds0 <n:ch> 

Example:

show ds0 32:1-4

The show command will produce a status message for each DS0 specified. For example, the mes-
sage for DS1 number 32, DS0 channel 10 would look similar to the following:

Settings for DS1 32, Channel 10:
    Type:            DATA
    Signaling:       NONE
    Up/Down:         UP
    CRV:             320 (assigned but not available)
    ISDN:            none
 

2. If groom DS0 settings are correct, skip remaining steps.

3. Set DS0 type to data for IP DS0 management

set ds0 <n:ch> type data

Example:

set ds0 32:6 type data

Example:

set ds0 32:1-24 type data

4. Set DS0 in service

set ds0 <n:ch> up

Example:

set ds0 10:1-24 up