Q-Logic 59021-05 Manuel D’Utilisation

4 – Installation

Powering Down a Switch

4-20

59021-05 A

10.

Display the list of firmware image files on the switch to confirm that the file 
was loaded. Refer to the 

 for more 

information.

cli (admin) $>image list

11.

Unpack the firmware image file to install the new firmware in flash memory.

cli (admin) $>image unpack filename

12.

Reset the switch to activate the new firmware. This will close the Telnet 
session by default.

cli (admin) $>reset

Simply unplugging the switch from the power source does not allow the switch to 
complete executing tasks and could lead to flash memory corruption. For this 
reason, open a Telnet session and use the Shutdown command to initiate an 
orderly shut down, then power down the switch. Refer to the 

.