Q-Logic 8C/16 Manuel D’Utilisation
A – Command Line Interface
Hotreset Command
59022-06 A
A-15
Q
Hotreset Command
Resets the switch for the purpose of activating the pending firmware without
disrupting traffic. This command terminates all management sessions and saves
all configuration information. After the pending firmware is activated, the
configuration is recovered. This process takes less than 80 seconds.
disrupting traffic. This command terminates all management sessions and saves
all configuration information. After the pending firmware is activated, the
configuration is recovered. This process takes less than 80 seconds.
Authority
Admin
Syntax
hotreset
Notes
Non-disruptive firmware activation is possible under the following conditions:
The active firmware must be version 2.0 or greater and the new firmware to
be activated must be a version greater than 2.0.
be activated must be a version greater than 2.0.
The fabric must be stable. This means that no configuration changes can be
in progress, and switch and device connections are not being added or
removed. Furthermore, a non-disruptive activation cannot occur if any port in
the fabric is in the diagnostic operational state.
in progress, and switch and device connections are not being added or
removed. Furthermore, a non-disruptive activation cannot occur if any port in
the fabric is in the diagnostic operational state.
This command clears the event log and all counters.