Q-Logic 8C/16 Manuel D’Utilisation

A – Command Line Interface
Set Setup Command

A-44

59022-06 A

Q

The following is an example of the Set Setup SNMP command:

SANbox2 #> admin start

SANbox2 (admin) #> set setup snmp

  A list of attributes with formatting and current values will follow.

  Enter a new value or simply press the ENTER key to accept the current value.

  If you wish to terminate this process before reaching the end of the list

  press 'q' or 'Q' and the ENTER key to do so.

  Trap Severity Options

  ---------------------

  unknown, emergency, alert, critical, error, warning, notify, info, debug, mark

  Contact             (string, max=32 chars)       [<sysContact undefined]

AdminTimeout

Specifies the amount of time in minutes the switch 
waits before terminating an idle Admin session. Zero 
(0) disables the time out threshold. The default is 30, 
the maximum is 1440.

TempMonitoringWarning

Warning temperature threshold in °C above which a 
warning condition alarm is generated. The default is 
65 °C.

TempMonitoringFailure

Failure temperature threshold in °C above which a 
failure condition alarm is generated. The default is 70 
°C.

TempFailurePortShutdown

Enables (True) or disables (False) the switch’s ability 
to place all ports down when the internal temperature 
exceeds the failure threshold. The default is False.

SecurityEnabled

Enables (True) or disables (False) the enforcement of 
account names and passwords. The default is False.

LocalLogEnabled

Enables (True) or disables (False) the saving of log 
information on the switch. The default is True.

RemoteLogEnabled

Enables (True) or disables (False) the recording of 
the switch event log on a remote host that supports 
the syslog protocol. The default is False.

RemoteLogHostAddress

The IP address of the host that will receive the switch 
event log information if remote logging is enabled. 
The default is 10.0.0.254.