Q-Logic 8C/16 Manuel D’Utilisation

A – Command Line Interface
Set Setup Command

A-42

59022-06 A

Q

Changes SNMP and system configuration settings. The switch maintains one 
SNMP configuration and one system configuration.

Admin

snmp
system

snmp
Prompts you in a line-by-line fashion to change SNMP configuration settings. 

 describes the SNMP fields. For each parameter, enter a new value or 

press the Enter key to accept the current value shown in brackets.

Contact

Specifies the name of the person to be contacted to respond to 
trap events. The default is undefined.

Location

Specifies the name of the switch location. The default is 
undefined.

Trap [1-5] Address

Specifies the workstation IP address to which SNMP traps are 
sent. The default address for trap 1 is 10.0.0.254. The default 
address for traps 2–5 is 0.0.0.0. Addresses, other than 0.0.0.0, 
for all traps must be unique.

Trap [1-5] Port

Specifies the workstation port to which SNMP traps are sent. 
The default is 162.

Trap [1-5] Severity

Specifies the severity level to use when monitoring trap events. 
The default is Warning

Trap [1-5] Version

Specifies the SNMP version (1 or 2) to use in formatting traps. 
The default is 2.

Trap [1-5] Enabled

Specifies whether traps (event information) are enabled or 
disabled (default).

ReadCommunity

Read community password that authorizes an SNMP agent to 
read information from the switch. This is a write-only field. The 
value on the switch and the SNMP management server must 
be the same. The default is “public”.

WriteCommunity

Write community password that authorizes an SNMP agent to 
write information to the switch. This is a write-only field. The 
value on the switch and the SNMP management server must 
be the same. The default is “private”.