Samsung RM255BABB Manuel D’Utilisation

The evaporator is located in the bottom of the
refrigerator.
1. Take off the partition in the refrigerator.
2. Take off the evaporator cover in the refrigerator.
3. Disconnect the wire connector.(Heater and 

Thermistor)

4. Desolder the capillary tube and the suction

line from the evaporator.

5. Remove the evaporator.
6. With a file, score the capillary tube just

upstream of the soldered point. Break off the
soldered section to help prevent solder from
plugging the tube during soldering.

7. Place a new evaporator and braze the suction 

and capillary tube to the evaporator using silver 
solder.

8. Install a replacement dryer.
9. Evacuate and recharge the system using 

reasonable procedures.

The refrigerator thermistor is located inside the
refrigerator light cover
1. Put your finger into the side groove of the lamp

cover,and pull the cover to separate.

2. Remove the screw in the lower part of

Ductwork,and pull the Thermistor cover.

3. Separate the housing inside the of Thermistor

cover, and replace the sensor.

Fresh/Arctic Select Zone Thermistor is located in the
lower part of evaporator cover
1. Unscrew both sides of the Thermistor cover.
2. Remove Thermistor cover by pulling it out.
3. Remove the tapes inside of cover, and remove

the front side Insulation to replace the Thermistor.

Suction Line

Ductwork

Thermistor

Thermistor cover

Thermistor

Capillary Tube

Bimetal

Thermistor

Thermistor cover

56

56