Dolmar PC-6430 Manuel D’Utilisation

28

Entire Power Cut

Clean exterior, check for damage. In case of damage,
have repaired by a qualified service center immediately

Cutting disc

Inspect regularly for damage and wear.

7

Clutch

Have inspected at a service center.

Protection hood

Clean, Check position (impact plate)

17

Cutting disc

Inspect for damage and make sure the cutting wheel is

7

right for the job

V-belt

Check V-belt tension

14

Protective hood

Adjust position

Combination switch,

Functional check

Safety locking button,

Functional check

Throttle lever

Functional check

17

Tank cap

Check for tightness

Air filter

Clean,

 

(poss. more often), replace foam pre-filter after

20 hours of operation

21

Idle speed

Check (cutting disc must not turn on idle)

19

Extreme dust

Clean filter insert (paper cartridge)

21

Starter housing

Clean to ensure proper air cooling

12

Starter cable

Check for damage

23

V-belt

Check V-belt tension, inspect for damage and wear

20

Air filter insert

Clean, replace after 

100 operating hours

22

Spark plug

Check and replace if necessary

22-23

Muffler

Check tightness of mounting

12

Suction head

Replace

23

Fuel tank

Clean

Entire Power Cut

Check at an authorized service center

Entire Power Cut

Clean exterior, check for damage. In case of damage,
have repaired by a qualified service center immediately

Cutting disc

Remove and clean

13

Fuel tank

Empty and clean

Carburetor

Run empty

To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be
performed regularly. Guarantee claims can be recognized only if this work is performed regularly and properly. Failure to perform
the prescribed maintenance work can lead to accidents!

Users of the Power Cut must not perform any maintenance work not described in this Instruction Manual. All such work must be
carried out by a DOLMAR service center.

Page

The maintenance and repair of modern cutoff saws and their safety-related components requires qualified technical training and a
workshop equipped with special tools and testing devices.
We therefore recommend that you consult a DOLMAR service center for all work not described in this instruction manual.
The DOLMAR service centers have all the necessary equipment and skilled and experienced personnel, who can work out cost-
effective solutions and advise you in all matters.
Please contact your nearest service center (list enclosed) or the general trading company or importer (see last page), who will gladly
provide you with the address of your nearest DOLMAR service center.

Reliable long-term operation, as well as the safety of your Power Cut, depend among other things on the quality of the spare parts
used. Use only original DOLMAR parts, marked

Only original parts are from the same production line as the original unit and therefore ensure the highest possible quality of materials,
dimensions, functioning and safety.
Only original spare parts and accessories guarantee the highest quality in material, dimensions and function.
Original spare parts and accessories can be obtained from your local dealer. He will also have the spare part lists to determine the
required spare part numbers, and will be constantly informed about the latest improvements and spare part innovations.
Please bear in mind that if parts other than original DOLMAR spare parts are used, this will automatically invalidate the DOLMAR
product guarantee.
We will furthermore not accept any liability damages arising from the use of non-DOLMAR spare parts.