Dolmar PC-6430 Manuel D’Utilisation

29

Cutting disc does not
start turning

Clutch

Engine runs

Damage to clutch

Cutting disc runs in idle

Carburetor,

Cutting disc runs

Incorrect idle speed,

clutch

blocked clutch

Engine does not start or

Ignition system

Ignition spark

Malfunction in fuel supply system, com-

only with difficulty

pression system, mechanical malfunction.

No ignition spark

Switch on STOP, fault or short-circuit in the
wiring, plug cap or spark plug defective.

Fuel supply

Fuel tank is filled

Choke in wrong position, carburetor defective,
suction head dirty, fuel line bent or interrupted.

Compression

Inside

Cylinder base packing ring defective, radial

system

shaft packings defective, cylinder or piston rings
defective

Outside

Spark plug does not seal.

Mechanical

Starter does not engage

Spring in starter broken, broken parts

malfunction

inside the engine.

Engine starts, but

Fuel supply

Fuel tank is filled

Wrong idling adjustment, suction head or

dies immediately

carburetor dirty.
Tank venting defective, fuel line interrupted,
cable defective, STOP switch defective.
Decompression valve dirty

Insufficient power

Several systems

Engine speed is low

Air filter dirty, wrong carburetor adjustment,

may be involved

muffler clogged, exhaust channel in cylinder

simultaneously

clogged, spark arrester screen clogged

DOLMAR guarantees the highest quality and will therefore reimburse all costs for repair by replacement of damaged parts resulting
from material or production faults occurring within the guarantee period after purchase. Please note that in some countries particular
guarantee conditions may exist. If you have any questions, please contact your salesman, who is responsible for the guarantee of the
product.

Please note that we cannot accept any responsibility for damage caused by:

•

Disregard of the instruction manual.

•

Non-performance of the required maintenance and cleaning.

•

Incorrect carburetor adjustment.

•

Normal wear and tear.

•

Obvious overloading due to permanent exceeding of the upper performance limits.

•

The use of other than original DOLMAR cutting discs.

•

Use of force, improper use, misuse or accidents.

•

Damage from overheating due to dirt on the fan housing.

•

Work on the Power Cut by unskilled persons or inappropriate repairs.

•

Use of unsuitable spare parts or parts which are not original DOLMAR parts, insofar as they have caused the damage.

•

Use of unsuitable or old oil.

•

Damage related to conditions arising from lease or rent contracts.

Cleaning, servicing and adjustment work is not covered by the guarantee. All repairs covered by the guarantee must be performed by
a DOLMAR service center.