Enterasys ssr-atm29-02 Mode D'Emploi
Chapter 9: Configuring Unicast Routing on the SSR
132
CoreWatch Users Guide
Configuration Expert adds the interfaces on which RIP is enabled to the list of
interfaces found in the RIP Enabled IP Interfaces object. Deleting the interface from that
object will disable RIP on the interface, but the interface will still be configured for IP
and available as an IP interface.
interfaces found in the RIP Enabled IP Interfaces object. Deleting the interface from that
object will disable RIP on the interface, but the interface will still be configured for IP
and available as an IP interface.
Adding Trusted Gateways
A trusted gateway is a router that is trusted to supply routing information. By default, all
routers on a subnet are trusted to supply routing information. If trusted gateways are
specified, only updates from those gateways are accepted. Add trusted gateways if you
want the SSR to accept RIP updates from only specific sources.
routers on a subnet are trusted to supply routing information. If trusted gateways are
specified, only updates from those gateways are accepted. Add trusted gateways if you
want the SSR to accept RIP updates from only specific sources.
To add trusted gateways:
1.
Start Configuration Expert if you have not already done so.
2.
Open the configuration file you want to modify and then double-click that file’s
Routing Configuration object.
Routing Configuration object.
3.
Double-click the IP Routing Configuration object.
4.
Double-click the IP Unicast Routing object and then double-click the RIP Routing
object. Double-click the RIP Trusted Gateways object.
object. Double-click the RIP Trusted Gateways object.
5.
Click the Configure New RIP Trusted Gateway object.
6.
In the RIP Trusted Gateway dialog box that appears, enter the IP address or host name
of a source from which you want the SSR to accept RIP updates.
of a source from which you want the SSR to accept RIP updates.
7.
Click OK.
Configuration Expert adds the trusted gateway to the list of those found in the RIP
Trusted Gateways object. The SSR will accept RIP updates only from the sources you
include in this list.
Trusted Gateways object. The SSR will accept RIP updates only from the sources you
include in this list.
8.
through
until you create the desired list of trusted gateways.
Adding Source Gateways
Add source gateways if you want to add routers that send RIP updates directly rather
than using broadcast or multicast messages. Updates to source gateways are not affected
by the setting of the interface RIP Packet Transmission option discussed on page page -
131. To add source gateways:
than using broadcast or multicast messages. Updates to source gateways are not affected
by the setting of the interface RIP Packet Transmission option discussed on page page -
131. To add source gateways:
1.
Start Configuration Expert if you have not already done so.
2.
Open the configuration file you want to modify and then double-click that file’s
Routing Configuration object.
Routing Configuration object.
3.
Double-click the IP Routing Configuration object.