3com S7906E Guide De Référence
1-30
pps: Specifies that the thresholds to be configured.
max-pps-values: Upper threshold to be set, in pps.
z
For a 100-Mbps port, this value ranges from 1 to 148810.
z
For a 1-Gbps port, this value ranges from 1 to 1488100.
z
For a 10-Gbps port, this value ranges from 1 to 14881000.
min-pps-values: Lower threshold to be set, in pps. The range of this argument is 1 to max-pps-values.
Description
Use the storm-constrain command to enable the storm constrain function for specific type of packets
and set the upper and lower thresholds.
Use the undo storm-constrain command to disable the storm constrain function for specific type of
packets.
By default, the storm constrain function is not enabled.
z
Do not use the storm-constrain command along with the multicast-suppression command or
the broadcast-suppression command. Otherwise, traffics may be suppressed in an
unpredictable way.
z
An upper threshold cannot be less than the corresponding lower threshold. Besides, do not
configure the two thresholds as the same value.
Examples
# Enable the storm constrain function for unicast packets on Ethernet 2/0/1, setting the upper and lower
threshold to 200 pps and 150 pps.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] storm-constrain unicast pps 200 150
storm-constrain control
Syntax
storm-constrain control { block | shutdown }
undo storm-constrain control
View
Layer 2 Ethernet interface view
Default Level
2: System level