3com S7906E Guide De Référence
1-8
Parameters
control-vlan vlan-id-list: Specifies the control VLANs used for receiving flush messages. The
vlan-id-list is expressed in the form of vlan-id-list = { vlan-id [ to vlan-id ] }&<1-10>, where the vlan-id
argument ranges from 1 to 4094 and &<1-10> indicates that you can provide up to ten VLAN IDs or
VLAN ID lists.
Description
Use the smart-link flush enable command to configure a VLAN for receiving flush messages, that is, a
receive control VLAN, on a port in Ethernet interface view or on all ports in system view.
Use the undo smart-link flush enable command to disable flush message processing.
By default, flush messages are not processed.
Note that:
z
If no VLAN is specified, VLAN 1 applies.
z
This command cannot be used on member port of an aggregation group or service loopback group.
Related commands: flush enable.
Examples
# Enable GigabitEthernet 2/0/1 to process the flush messages received in VLAN 1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] smart-link flush enable
# Enable Layer-2 aggregate interface 1 to process the flush messages received in VLAN 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] smart-link flush enable
smart-link group
Syntax
smart-link group group-id
undo smart-link group group-id
View
System view
Default Level
2: System level
Parameters
group-id: Smart link group ID. The minimum value is 1, while the maximum value is 48.
Description
Use the smart-link group command to create a smart link group and enter smart link group view.
Use the undo link-aggregation group command to remove a smart link group.