3com S7906E Guide De Référence
1-16
Field
Description
LLDP-MED extend TLV
MED related LLDP TLVs, including:
z
Capabilities TLV
z
Network Policy TLV
z
Location Identification TLV
z
Extended Power-via-MDI TLV
z
Inventory TLV, which can be hardware
revision TLV, firmware revision TLV, software
revision TLV, serial number TLV,
manufacturer name TLV, model name TLV,
and asset id TLV.
revision TLV, firmware revision TLV, software
revision TLV, serial number TLV,
manufacturer name TLV, model name TLV,
and asset id TLV.
lldp admin-status
Syntax
lldp admin-status { disable | rx | tx | txrx }
undo lldp admin-status
View
Ethernet interface view, port group view
Default level
2: System level
Parameters
disable: Specifies the Disable mode. A port in this mode does not send or receive LLDPDUs.
rx: Specifies the Rx mode. A port in this mode receives LLDPDUs only.
tx: Specifies the Tx mode. A port in this mode sends LLDPDUs only.
txrx: Specifies the TxRx mode. A port in this mode sends and receives LLDPDUs.
Description
Use the lldp admin-status command to specify the LLDP operating mode for a port or all the ports in a
port group.
Use the undo lldp admin-status command to restore the default LLDP operating mode.
The default LLDP operating mode is TxRx.
Examples
# Configure the LLDP operating mode as Rx for GigabitEthernet 2/0/3.
<Sysname> system-view
[Sysname] interface gigabitethernet2/0/3
[Sysname-GigabitEthernet2/0/3] lldp admin-status rx
lldp check-change-interval
Syntax
lldp check-change-interval value