3com S7906E Guide De Référence

 

1-22 

[Sysname] interface gigabitethernet2/0/3 

[Sysname-GigabitEthernet2/0/3] lldp management-address-format string 

lldp management-address-tlv [ ip-address ] 

undo lldp management-address-tlv 

Ethernet interface view, port group view 

2: System level 

ip-address: Management address to be set. 

Use the lldp management-address-tlv command to enable the management address sending. This 

command also sets the management address. 

Use the undo lldp management-address-tlv command to disable management address sending. 

By default, the management address is sent through LLDPDUs, and the management address is the 

primary IP address of the VLAN with the least VLAN ID among the VLANs whose packets are permitted 

on the port. If the primary IP address is not configured, the management address is 127.0.0.1. For 

information about VLAN, refer to VLAN Configuration in the Access Volume. 

Note that an LLDPDU carries only one management address. If you set the management address 

repeatedly, the latest one takes effect. 

# Set the management address to 192.6.0.1 for GigabitEthernet2/0/3. 

<Sysname> system-view 

[Sysname] interface gigabitethernet2/0/3 

[Sysname-GigabitEthernet2/0/3] lldp management-address-tlv 192.6.0.1 

undo lldp notification remote-change enable 

Ethernet interface view, port group view