3com S7906E Guide De Référence

 

1-9 

Table 1-3 display port command output description 

Interface Port 

name 

PVID 

Default VLAN ID of the port 

VLAN passing 

VLANs whose packets are allowed to pass through the port. 

Tagged 

VLANs whose packets are required to pass through the port tagged. 

Untagged 

VLANs whose packets are required to pass through the port untagged.

 

port interface-list 

undo port interface-list 

VLAN view 

2: System level 

interface interface-list: Specifies an Ethernet port list or Layer-2 aggregate interface list, in the format of 

interface-list = { interface-type interface-number [ to interface-type interface-number ] }&<1-10>, where 

&<1-10> indicates that you can specify up to 10 ports or port ranges. 

Use the port command to assign the specified access port(s) to the current VLAN. 

Use the undo port command to remove the specified access port(s) from the current VLAN. 

By default, all ports are in VLAN 1. 

Note that:  

z 

This command is only applicable on access ports. 

z 

All ports are access ports by default. However, you can manually configure the port type. For more 

information, refer to port link-type. 

z 

If you use this command to assign a Layer-2 aggregate interface to a VLAN, this command assigns 

the Layer-2 aggregate interface but not its member ports to the current VLAN. For detailed 

information about Layer-2 aggregate interfaces, refer to Link Aggregation Configuration in the 

Access Volume.  

Related commands: display vlan. 

# Assign GigabitEthernet 2/0/1 through GigabitEthernet 2/0/3 to VLAN 2. 

<Sysname> system-view 

[Sysname] vlan 2