3com S7906E Guide De Référence

 

1-24 

Refer to

 Table 1-5

 for description of the output. 

port hybrid protocol-vlan vlan vlan-id { protocol-index [ to protocol-end ] | all } 

undo port hybrid protocol-vlan { vlan vlan-id { protocol-index [ to protocol-end ] | all } | all } 

Ethernet interface view, port group view, Layer-2 aggregate interface view, 

2: System level 

vlan vlan-id: Specifies a VLAN ID, in the range 1 to 4094. 

protocol-index: Protocol index, in the range 0 to 15, specified by the users or assigned by the system 

automatically when the protocol-based VLAN is created. You can use the display protocol-vlan vlan 

all command to display the protocol indexes.  

to protocol-end: Specifies the end protocol index. The protocol-end argument must be greater than or 

equal to the beginning protocol index. The range of the protocol-end argument varies with device 

models. 

all: Specifies all protocols bound with vlan-id. 

Use the port hybrid protocol-vlan vlan command to associate the hybrid port(s) with a protocol-based 

VLAN.  

Use the undo port hybrid protocol-vlan command to remove the association. 

z 

In Ethernet interface view, this command only applies to the current port. 

z 

In port group view, this command applies to all ports in the port group. For information about port 

groups, refer to Ethernet Interface Configuration in the Access Volume. 

z 

In Layer-2 aggregate interface view, this command applies to the Layer-2 aggregate interface and 

all its member ports. After you perform the configuration, the system starts applying the 

configuration to the aggregate interface and its aggregation member ports. If the system fails to do 

that on the aggregate interface, it stops applying the configuration to the aggregation member ports. 

If it fails to do that on an aggregation member port, it simply skips the port and moves to the next 

port. For information about Layer-2 aggregate interfaces, refer to Link Aggregation Configuration in 

the Access Volume.  

Before issuing this command, make sure that you have made the following configurations: 

z 

Create a VLAN and associate it with specified protocols. 

z 

Configure the link type as hybrid. 

z 

Configure the port to allow the protocol-based VLAN to pass through.