3com S7906E Guide De Référence

 

1-22 

DLSw, FTP, HTTP, ICMP-echo, SNMP, TCP, UDP-echo, UDP-jitter test type view 

2: System level 

None 

Use the route-option bypass-route command to enable the routing table bypass function to test the 

direct connectivity to the direct destination. 

Use the undo route-option bypass-route command to disable the routing table bypass function. 

By default, the routing table bypass function is disabled. 

Note that after this function is enabled, the routing table is not searched, and the packet is directly sent 

to the destination in a directly connected network. 

# Enable the routing table bypass function. 

<Sysname> system-view 

[Sysname] nqa entry admin test 

[Sysname-nqa-admin-test] type icmp-echo 

[Sysname-nqa-admin-test-icmp-echo] route-option bypass-route 

source interface interface-type interface-number 

undo source interface 

ICMP-echo test type view 

2: System level 

interface-type interface-number: Interface type and the interface number of the source interface of a 

probe packet. 

Use the source interface command to specify the IP address of an interface as the source IP address 

of ICMP-echo probe requests. 

Use the undo source interface command to remove the IP address of an interface as the source IP 

address of ICMP-echo probe requests.