3com S7906E Guide De Référence
1-1
1
VRRP Configuration Commands
z
The term switch in this document refers to a switch in a generic sense or a Layer 3 switch.
z
At present, the interfaces that VRRP involves can only be VLAN interfaces unless otherwise
specified.
IPv4-Based VRRP Configuration Commands
display vrrp
Syntax
display vrrp [ verbose ] [ interface interface-type interface-number [ vrid virtual-router-id ] ]
View
Any view
Default Level
1: Monitor level
Parameters
verbose: Displays detailed state information of VRRP.
interface interface-type interface-number: Displays VRRP state information of the specified interface.
interface-type interface-number specifies an interface by its type and number.
vrid virtual-router-id: Displays state information of the specified VRRP group. virtual-router-id specifies
a VRRP group by its group number, in the range 1 to 255.
Description
Use the display vrrp command to display the state information of VRRP.
If you do not specify verbose, only the brief state information of VRRP is displayed.
If you specify both an interface and a VRRP group, only the state information of the specified VRRP
group is displayed; if you only specify an interface, the state information of all the VRRP groups on the
interface is displayed; if you specify neither, the state information of all the VRRP groups on the device
is displayed.
Examples
# Display brief information about all VRRP groups on the device.