3com S7906E Guide De Référence

 

1-1 

bpdu-tunnel dot1q stp 

undo bpdu-tunnel dot1q stp 

Ethernet interface view, Layer-2 aggregate interface view, port group view 

2: System level 

None 

Use the bpdu-tunnel dot1q stp command to enable BPDU tunneling for STP on the current port or 

ports.  

Use the undo bpdu-tunnel dot1q stp command to disable BPDU tunneling for STP on the port or 

ports.  

By default, BPDU tunneling for STP is disabled.  

Note that: 

z 

Configuration made in Ethernet interface view takes effect on the current port only. Configuration 

made in Layer-2 aggregate interface view takes effect only on the Layer-2 aggregate interface. 

Configuration made in port group view takes effect on all ports in the port group.  

z 

Configuration made on an aggregation group member port takes effect after the port exits the 

aggregation group. For detailed information about link aggregation, refer to Link Aggregation 

Configuration in the Access Volume.  

z 

Before you can enable BPDU tunneling for STP on a port, disable STP on the port first.  

# Enable BPDU tunneling for STP on GigabitEthernet 2/0/1.  

<Sysname> system-view 

[Sysname] interface GigabitEthernet 2/0/1 

[Sysname-GigabitEthernet2/0/1] stp disable 

[Sysname-GigabitEthernet2/0/1] bpdu-tunnel dot1q stp 

# Enable BPDU tunneling for STP on all the ports in port group 1.