3com S7906E Guide De Référence

 

1-5 

# Configure port Ethernet 2/0/1 as the outbound mirroring port of remote port mirroring group 1 in 

system view. 

<Sysname> system-view 

[Sysname] mirroring-group 1 remote-source 

[Sysname] mirroring-group 1 monitor-egress Ethernet 2/0/1 

# Configure port Ethernet 2/0/2 as the outbound mirroring port of remote port mirroring group 2 in 

Ethernet port view. 

<Sysname> system-view 

[Sysname] mirroring-group 2 remote-source 

[Sysname] interface Ethernet 2/0/2 

[Sysname-Ethernet2/0/2] mirroring-group 2 monitor-egress 

mirroring-group group-id monitor-port monitor-port-id 

undo mirroring-group group-id monitor-port monitor-port-id 

System view 

2: System level 

group-id: Port mirroring group number, in the range of 1 to 4. 

monitor-port-id: Port index. You need to provide this argument in the form of interface-type 

interface-number, where interface-type is the port type and interface-number is the port number.  

Use the mirroring-group monitor-port command to configure the destination port for a port mirroring 

group.  

Use the undo mirroring-group monitor-port command to remove the destination port from a port 

mirroring group.  

Note that: 

z 

A port mirroring group can contain only one destination port. 

z 

The destination port cannot be a member port of the current mirroring group. 

z 

The destination mirroring port can be an access, trunk, or hybrid port. It must be assigned to the 

remote mirroring VLAN.  

z 

A remote source port mirroring group cannot contain destination ports. 

z 

Before configuring the destination port for a port mirroring group, make sure the port mirroring 

group exists. 

z 

Do not enable STP, RSTP, or MSTP on the destination port. Otherwise, the mirroring function may 

be affected.