Gestetner dsc224 Mode D'Emploi
Remote Maintenance by telnet
115
7
❖
❖
❖
❖ Protocol Configuration
To change the protocol settings, use the following command. You can specify
the setting for [lpr] or [ipp].
• lpr
the setting for [lpr] or [ipp].
• lpr
msh> spoolsw lpr {on |off}
• ipp
msh> spoolsw ipp {on |off}
Changing the Host Name
Use the hostname command to change the printer name.
msh> hostname interface_name printer_name
*1
If you did not enter the interface name, it will be automatically set to the Ethernet in-
terface.
*2
If you install the 802.11b Interface Kit, you can set the command.
*3
If you install the 1394 Interface Unit, you can set the command.
Note
❒ Enter the printer name using up to 13 characters.
❒ You cannot use a printer name starting with RNP or rnp.
❒ The Ethernet interface and IEEE 802.11b interface will have the same printer
❒ You cannot use a printer name starting with RNP or rnp.
❒ The Ethernet interface and IEEE 802.11b interface will have the same printer
name.
WINS
Use the wins command to configure the WINS server settings.
For more information about WINS server settings, see p.135 “Configuring a
WINS Server”.
For more information about WINS server settings, see p.135 “Configuring a
WINS Server”.
❖
❖
❖
❖ Viewing setting
The following command displays the WINS server IP address.
msh> wins
Example out put:
Example out put:
wins: primary server 0.0.0.0 secondary server 0.0.0.0
DHCP current config:
p r i m a r y s e r v e r 1 9 2 . 1 6 8 . 1 0 . 1 s e c o n d a r y s e r v e r
192.168.10.2
hostname RNP620B47 ScopeID
DHCP current config:
p r i m a r y s e r v e r 1 9 2 . 1 6 8 . 1 0 . 1 s e c o n d a r y s e r v e r
192.168.10.2
hostname RNP620B47 ScopeID
interface name
Interface to be configured
ether
Ethernet interface
IEEE 802.11b interface
ip1394
IEEE 1394 interface