Gestetner dsc224 Mode D'Emploi
Remote Maintenance by telnet
117
7
CCCC
Type the new password.
New password:
Note
❒ The password must consist of 3 to 8 alphanumeric characters and symbols.
Upper and lower case characters are considered unique. For example, R is
different from r.
different from r.
❒ The password is the same as that used in the configuration of the Network
Interface Board using a Web Browser and that used in the NIB Setup Tool.
If you change a password from telnet, the other passwords are also
changed.
If you change a password from telnet, the other passwords are also
changed.
DDDD
Type the new password once again.
Retype new password:
SNTP
The printer clock can be synchronized with a NTP server clock using the Simple
Network Time Protocol (SNTP). To change the SNTP settings, use the sntp com-
mand. Confirm with the network administrator that the NTP server settings are
correct.
Network Time Protocol (SNTP). To change the SNTP settings, use the sntp com-
mand. Confirm with the network administrator that the NTP server settings are
correct.
Limitation
❒ SNTP supports the NTP servers running xnptd V3 and V4.
❖
❖
❖
❖ Reference
msh> sntp
❖
❖
❖
❖ NTP Server Address Configuration
You can specify the IP address of the NTP server.
msh> sntp server IP_address
msh> sntp server IP_address
❖
❖
❖
❖ Interval Configuration
You can specify the interval at which the printer synchronizes with the oper-
ator-specified NTP server.
msh> sntp interval polling_time
ator-specified NTP server.
msh> sntp interval polling_time
Note
❒ The factory default setting is 3600 seconds.
❒ You can set the interval from 16 to 16384 seconds.
❒ If you set 0, the printer synchronizes with the NTP server only when you
❒ You can set the interval from 16 to 16384 seconds.
❒ If you set 0, the printer synchronizes with the NTP server only when you
turn the printer on. After that, the printer does not synchronize with the
NTP server.
NTP server.