Canon LV-7292M Manuel D'Instructions

68

When the projection lamp of the projector 

reaches its end of life, the Lamp replacement 

icon appears on the screen and LAMP 

REPLACE indicator lights yellow. Replace the 

lamp with a new one promptly. The timing when 

the LAMP REPLACE indicator should light is 

depending on the lamp mode.

Follow these steps to replace the 

lamp.

For continued safety, replace with a lamp of the 

same type. Do not drop a lamp or touch a glass 

bulb! The glass can shatter and may cause 

injury.

Allow a projector to cool for at least one hour 

before you open the Lamp Cover. The inside 

of the projector can become very hot.

Unplug the AC power cord. Let the projector 

cool for at least one hour.

Loosen the three (3) screws that secure the 

lamp. Lift the lamp out of the projector by 

using the handles.

Replace the lamp with a new one and 

secure the three (3) screws. Make sure that 

the lamp is set properly. Close the lamp 

cover and secure the screw.

Loosen the screw and open the lamp cover.

Connect the AC power cord to the projector 

and turn on the projector.

Screw

Handles

Screw

Lamp Cover

Screw

Screw

When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp 

may be broken.

If replacing the lamp of a projector which has been installed on the ceiling, you should always 

assume that the lamp is broken, and you should stand to the side of the lamp cover, not 

underneath it. Remove the lamp cover gently. Small pieces of glass may fall out when the lamp 

cover is opened. If pieces of glass get into your eyes or mouth, seek medical advice immediately.



     • The image will be displayed for about 10 seconds.

     •  The Lamp replacement icon will not appear when the Display function is set to 

Off (p.53), during Freeze (p.28), 

or 

Blank (p.29).

OK

POWER

AUTO SET

MENU

LAMP REPLACE

WARNING

VOL

VOL

See "Lamp Counter" on page 62.

Lamp