Canon LV-7292M Manuel D'Instructions

Maintenance and Cleaning

Filter prevents dust from accumulating on the optical elements inside the projector. Should the Filter

become clogged with dust particles, it will reduce cooling fans’ effectiveness and may result in internal

heat buildup and adversely affect the life of the projector. If a “Filter warning” icon appears on the

screen, replace the Filter immediately. Replace the filter by following the steps below.

CAUTION

- Do not operate the projector with the filter

removed. Dust may accumulate on the optical

elements degrading picture quality.

- Do not put anything into the air vents. Doing

so may result in malfunction of the projector.

- Do not wash the filter with water or any other

liquid Matter. Otherwise the filter may be

damaged.

RECOMMENDATION

We recommend avoiding dusty/smoky

environments when you operate the

projector. Usage in these environments

may cause poor image quality.

When using the projector under dusty or

smoky conditions, dust may accumulate

on a lens, LCD panels, or optical elements

inside the projector degrading the quality of a

projected image. When the symptoms above

are noticed, contact your authorized dealer or

service center for proper cleaning.

Be sure to reset the Filter counter after cleaning

or replacing the filter.

Press the MENU button to display the

On-Screen Menu. Use the Point ▲▼ buttons

to select Setting and then press the Point ►

or the OK button.
Use the Point ▲▼ buttons to select

Filter

counter and then press the Point ► or the

OK button. Use the Point ▲▼buttons to

select

Filter counter reset and then press

the OK button.

Filter counter Reset?

appears. Select

Yes to continue.

Resetting the Filter Counter

Filter counter reset

Filter counter

Reset? appears.

Select

Yes,

then another

confirmation box

appears.
Select

Yes again

to reset the Filter

counter.

Another confirmation dialog box appears,

select

Yes to reset the Filter counter.

Replacing the Filter

Turn off the projector, and unplug the AC

power cord from the AC outlet.
Place the latch in the OPEN position and

pull out the filter in the arrow direction.

Slide the new filter (along the guide

rails. Make sure that the filter is inserted

completely.) Place the latch back in the

LOCK position.

Filter

Latch

Connect the AC power cord to the

projector and turn on the projector.

Reset the filter counter.

OPEN

LOCK



Note:

• When replacing the

filter, it is required

a certain space to

pull out the filter

completely.

• When installing the

projector, install the

projector with keeping

a certain space for

replacing the filter.