Cisco Cisco IOS Software Release 12.0(19)S

The following ISE line cards are supported with Cisco IOS Release 12.0(19)S or later:

4-OC12X/POS-SM-SC: 4-Port POS OC-12/STM-4 with Extended Feature Set Line Card 
(concatenated)

4-CHOC12/DS3-IR-SC: 4-Port Channelized OC-12/STM-4 to DS-3/E3 Line Card 

16-OC3X/POS-IR-LC: 16-Port Packet-Over-SONET OC-3/STM-1 with Extended Feature Set Line 
Card (concatenated)

16-CHOC3/DS3-IR-LC: 16-Port Channelized OC-3/STM-1 to DS-3/E3 Line Card 

See the following sections to configure the ISE features.

 

By default, all interfaces on a new line card are disabled. To enable an interface, you must first choose 
the interface, and then issue the no shutdown command. When an interface on the line card is enabled 
with no additional changes to the configuration, the default interface configuration parameters are used. 

This section describes the commands used to and modify the parameters on an interface. Each command 
includes information on the default setting. Each task in the following list is identified as either required 
or optional.

 (required)

 (optional)

 (optional)

 (required)

 (optional)

 (optional)

For additional information on the Cisco IOS interface commands described in this section, refer to the 
Cisco Systems publication Cisco IOS Release 12.0 Interface Command Reference.

For information on the configuration and use of Bit Error Rate Testing (BERT), refer to the 
appropriate hardware installation publications as specified in 

.