Cisco Cisco IOS Software Release 12.0(21)S

To terminate a ping session, type the escape sequence—by default, Ctrl-Shift-6.

This section provides the following configuration examples:

The following example helps verify the connectivity of a specific PVC by sending an ATM OAM packet 
and confirms the connectivity when it is successful:

Router# show atm pvc 0/500

VC 0/500 doesn't exist on interface ATM1/0 - cannot display

ATM1/1.1: VCD: 2, VPI: 0, VCI: 500

UBR, PeakRate: N/A (UBR VC)

AAL5-LLC/SNAP, etype:0x0, Flags: 0xC20, VCmode: 0x0

OAM frequency: 10 second(s), OAM retry frequency: 1 second(s)

OAM up retry count: 3, OAM down retry count: 5

OAM END CC Activate retry count: 3, OAM END CC Deactivate retry count: 3

OAM END CC retry frequency: 30 second(s),

OAM SEGMENT CC Activate retry count: 3, OAM SEGMENT CC Deactivate retry count: 3

OAM SEGMENT CC retry frequency: 30 second(s),

OAM Loopback status: OAM Received

OAM VC state: Verified

ILMI VC state: Not Managed

OAM END CC status: OAM CC Ready

OAM END CC VC state: Verified

OAM SEGMENT CC status: OAM CC Ready

OAM SEGMENT CC VC state: Verified

VC is managed by OAM.

InARP frequency: 15 minutes(s)

InPkts: 289035, OutPkts: 217088, InBytes: 21165546, OutBytes: 17367793

InPRoc: 289039, OutPRoc: 289274

InFast: 0, OutFast: 0, InAS: 1, OutAS: 2

Out CLP=1 Pkts: 0

OAM cells received: 119900

F5 InEndloop: 119809, F5 InSegloop: 0,

F5 InEndcc: 0, F5 InSegcc: 0, F5 InAIS: 92, F5 InRDI: 0

OAM cells sent: 119902

F5 OutEndloop: 119810, F5 OutSegloop: 0,

F5 OutEndcc: 0, F5 OutSegcc: 0, F5 OutAIS: 0, F5 OutRDI: 92

OAM cell drops: 0

Status: UP

The following example shows sample output for the ping atm interface atm command in normal mode: