Cisco Cisco IOS Software Release 12.2

The software described in these release notes runs on several Cisco NI-2 DSLAM platforms, 
including the Cisco 6015, Cisco 6160, and Cisco 6260 DSLAMs.

A complete list of all DSL hardware product related documentation is available at the following URL: 

http://www.cisco.com/univercd/cc/td/doc/product/dsl_prod/index.htm

A complete list of all DSL Cisco IOS product related documentation is available at the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/dsl_prod/ios_dsl/index.htm

In the Cisco ATM software manuals, look for information pertaining to the LightStream 1010, which uses 
the same software base as the Cisco NI-2 DSLAMs. ATM manuals are available at the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/atm/index.htm

CSCdv38294

 VPI/VCI values for provisioned PVC do not match the provisioned values when 
you select a VCI value of 0 for any non-terminating PVC (that is, a PVC not 
terminating at atm0/0).

CSCdv80202

The shdsl profile has a different format between Cisco IOS Release 12.1(7)DA and 
Cisco IOS Release 12.2(5).

CSCdv86663

When you configure an interface bandwidth statement on a Cisco 6260 DSLAM 
ATM interface, the default bandwidth value for the interface as seen in the 
show interface atm command may appear in the show running-config output.

CSCdw03128

Cisco 6260 DSLAM SNMP agent returns incorrect ifType for SHDSL interfaces.

CSCdw25440

Using the command show atm vc interface atm slot/port vpi vci where vpi and vci 
are the VPI and VCI numbers in a SVC configuration can cause the DSLAM to 
reload. This usually happens when the CPE is connected but the SVC is not yet 
established.

CSCdw34798

Invalid cells are passed to network port on a valid VC. The 4xDMT line card does 
not discard cells with HEC errors and stamps each cell going to the DSLAM with 
a valid HEC. The switch can then pass these corrupt cells out the WAN interface if 
they appear to have a valid and provisioned VPI and VCI.

CSCdw41743

After 54 days of uptime, the system experienced an unexpected reload immediately 
preceded by the messages: System reloads with message SYS-2-WATCHDOG 
process=IMA CORE.

CSCdw47576

An NI-2 DSLAM reloads after a few ALIGN-1-FATAL error messages.

CSCdw65903

An error can occur with management protocol processing. Please use the following 
URL for further information: