Cisco Cisco IOS Software Release 12.2(2)XG
NM-AIC-64, Contact Closure Network Module
alarm-interface
38
Cisco IOS Release 12.2(2)XG
alarm-interface
To enter the alarm interface mode and configure the alarm interface controller (AIC), use the
alarm-interface command in configure interface mode. To leave the alarm-interface mode, use the exit
command.
alarm-interface command in configure interface mode. To leave the alarm-interface mode, use the exit
command.
alarm-interface slot-number
Syntax Description
Defaults
No default behavior or values.
Command Modes
Configure interface
Command History
Examples
The following example shows how the alarm-interface command is used in conjunction with the
ip address command:
ip address command:
Router(config)# alarm-interface 5
Router(config-aic)# reset
Router(config-aic)# ip address 10.2.130.105
Router(config-aic)# exit
Related Commands
slot number
The number of the port in which the AIC is installed.
Release
Modification
12.2(2)XG
This command was introduced for the Cisco 2600 series and the
Cisco 3600 series.
Cisco 3600 series.
Command
Description
ip address
Sets a primary or secondary IP address for an interface.
reset
Resets the AIC CPU.