Cisco Cisco IOS Software Release 12.4(2)XB6
151
Cisco Packet Data Serving Node (PDSN) Release 4.1 for Cisco IOS Release 12.4(15)XR7
Cisco Packet Data Serving Node (PDSN) Release 4.1 for Cisco IOS Release 12.4(15)XR7
•
RFC 2401, Security Architecture for the Internet Protocol
•
RFC 2402, IP Authentication Header
•
RFC 2406, IP Encapsulating Security Payload (ESP)
•
RFC 3012, Mobile IPv4 Challenge/Response Extension
Configuration Tasks
This section describes the steps for configuring the Cisco PDSN software on the MWAM platform. Prior
to configuring instances of the PDSN on MWAM application cards, you must create a base Catalyst 6500
or 7600 configuration. Refer to the Cisco Multi-processor WAN Application Module Installation and
Configuration Note for more information.
to configuring instances of the PDSN on MWAM application cards, you must create a base Catalyst 6500
or 7600 configuration. Refer to the Cisco Multi-processor WAN Application Module Installation and
Configuration Note for more information.
System Requirements
This section describes the system requirements for Cisco IOS Release 12.4(15)XR2:
•
•
•
•
•
•
Memory Requirements
shows the memory requirements for the PDSN Software Feature Set that supports the SAMI
card on the Cisco7600 Internet router platform. The table also lists the memory requirements for the IP
Standard Feature Set (for the Cisco PDSN).
Standard Feature Set (for the Cisco PDSN).
Table 12
Memory Requirements for the SAMI Blade on the Cisco 7600 Router
Platform
Software
Feature Set
Feature Set
Image Name
Flash
Memory
Required
Memory
Required
DRAM
Memory
Required
Memory
Required
Runs
From
From
Cisco 7600 Internet
Router
Router
PDSN Software Feature
Set
Set
12.4(15)XR-
c7svcsami-c6ik9s-mz.124-15.XR
c7svcsami-c6ik9s-mz.124-15.XR
(This is a bundled image)
128MB
2048MB
RAM