Cisco Cisco IOS Software Release 12.4(2)XB6

Perform the following procedure to fall back to another copy of the FPD and to complete the FPD 
upgrade that was interrupted: 

Power down the router and remove NPE-G2. 

For information on removing and installing the NPE-G2, see the 

 document

Remove the pre-installed jumper JP3 from the NPE-G2 board.

Insert the NPE-G2 into the router and power up the router.

Reload the Cisco IOS image.

Manually upgrade the FPD using the upgrade hw-module slot npe fpd file file-url command.

Verify that the FPD upgrade is complete using the show upgrade fpd progress command.

When the upgrade is complete, power down the router and remove the NPE-G2.

Re-install jumper JP3 on the NPE-G2 board.

Insert the NPE-G2 into the router, and power up the router.

Reload the Cisco IOS and verify that the upgrade was successful using the show hw-module slot npe 
fpd command.

This section provides the following configuration example:

The following example shows the output that is displayed when the FPD image package for the NPE-G2 
is upgraded using the upgrade hw-module slot npe fpd file command:

Router# upgrade hw-module slot npe fpd file 

% The following FPD(s) will be updated for NPE-G2 (H/W ver = 0.0) in NPE slot: