Cisco Cisco IOS Software Release 12.2(35)SE

CSCsi66554 

The SNMP bridge object dot1dStpRootPort now shows the stack switch root port number instead of 
the stack port ID of the member switch.

CSCsi74526 (Only Catalyst 3750-E switches) 

When removing a member switch from the stack and you enter the show tech-support privileged 
EXEC command or the show interfaces privileged EXEC command, the switch no longer resets.

CSCsi81369 

The switch now sends an EAP success packet to the client after a IEEE 802.1x multidomain 
authentication port t successfully reauthenticates. 

These sections provide updates to the product documentation:

These are the updates to the Getting Started Guides for the Catalyst 3750-E and Catalyst 3560-E 
switches:

This information should be included in the “Install and Connect to Devices in the 10-Gigabit 
Ethernet Slots” section:

When you install or remove the converter module, the mode on the switch changes from 
10-Gigabit Ethernet to Gigabit Ethernet or the reverse. During this mode change, data traffic on 
the other switch uplink ports (X2 transceiver or SFP module ports) might temporarily stop. 
When you install or remove an X2 transceiver or SFP module, traffic delay does not occur.

This information should be included in the “Troubleshooting Express Setup” section:

POST errors are usually fatal. Contact your Cisco technical support representative if your 
switch fails POST.

These sections contain the updates to the Software Configuration Guide for the Catalyst 3750-E and 
Catalyst 3560-E switches: