Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage
Chapter 4 Operation
342
78-4021139-01 Rev D
Perform the following steps.
1 Create the QAM on the USRM.
1 Create the QAM on the USRM.
a On the Platform - ConfigManager - Resource Create page, enter a unique
resource name in the CreateName field associated with the device type you
want to create.
Note: QAM names cannot contain spaces.
b Click Commit Changes.
c Repeat this for all resources to be added.
d Refresh the navigation tree. Either click the top-level USRM name or click
c Repeat this for all resources to be added.
d Refresh the navigation tree. Either click the top-level USRM name or click
the web browser refresh button.
Note: This causes the newly-added resources to display in the navigation
tree in the ResourceManager section.
2 Read the QAM settings. (Cisco QAMs only.)
a Select the Resource Manager - QAMs - QAM <QamName> - Chassis page.
b Enter the IP Address of the QAM's management port in the CtrlIpAddress
b Enter the IP Address of the QAM's management port in the CtrlIpAddress
field and click Commit Changes.
Note: This causes the USRM to read the QAM settings (frequency, TSID, etc.)
via SNMP and place the information in the USRM tables.
c Select the Resource Manager - QAMs - QAM <QamName> - QAM Channels
page.
d Verify the QAM settings, particularly that the Service Type (SDV, VOD) and
Admin States are set properly.
3 Assign service groups.
a Select the Resource Manager - QAMs - QAM <QamName> - Output Ports
page.
b Enter the Service Group ID associated with each port, then set the Admin
State to InService and click Commit Changes.
c Select the ResourceManager - Service Groups:Config page and verify the
AdminState is set to InService. If not, set it.
d Verify that sessions are created as follows.
i Monitor the EventLog tail.
ii Check the Resource Manager - QAMs - QAM <QamName> - Sessions
ii Check the Resource Manager - QAMs - QAM <QamName> - Sessions
page for video and MCP sessions.
iii On the Applications - McmisServer - MCP Sessions page, verify that
mini-carousels are created.
iv For a graphical view of sessions, select either the Applications - SdvSm -
Service Groups/Bandwidth page and click QamGraphic or select the
ResourceManager - ServiceGroups:Graphics page and click
QamComposition for the desired service group.