Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage
Adding and Deleting Service Groups to a USRM Using the Web Interface
78-4021139-01 Rev D
343
Notes: The Resource Manager page displays all video and mini-carousel
sessions created on a QAM carrier in the service group. All sessions
displays as yellow since all sessions are active. The SdvSm page displays
only video sessions (no mini-carousels). Sessions with users display as
yellow. Sessions without users display as orange (max mode only).
Updating Zone Configuration Information
This step is only required for sites using zones.
Perform the following steps to associate zone information with the service groups.
1 Select the Applications - SdvSm - Service Groups/Config page.
2 Enter the zone information for each service group.
3 Click Commit Changes.
This step is only required for sites using zones.
Perform the following steps to associate zone information with the service groups.
1 Select the Applications - SdvSm - Service Groups/Config page.
2 Enter the zone information for each service group.
3 Click Commit Changes.
Deleting Service Groups From a USRM
Deleting a service group and other resources from a USRM in release 1.5.0 or greater
requires a process that is a combination of procedures on the USRM as well as on the
DNCS. The basic flow of the process is as follows.
1 From the USRM, release all of the sessions associated with the service group in
1 From the USRM, release all of the sessions associated with the service group in
the Resource Manager.
2 From the DNCS, remove the service group from the USRM.
3 From the USRM, delete the service group from the SdvSm.
4 From the USRM, delete the service group from the QAM output ports.
5 From the USRM, delete the service group from the Resource Manager.
Note: You should open a tail of the USRM's EventLog to monitor the actions that
3 From the USRM, delete the service group from the SdvSm.
4 From the USRM, delete the service group from the QAM output ports.
5 From the USRM, delete the service group from the Resource Manager.
Note: You should open a tail of the USRM's EventLog to monitor the actions that
occur during the process.
The following sections explain each of these procedures in detail.
The following sections explain each of these procedures in detail.
Releasing Sessions From a Service Group in Resource Manager
Perform the following steps to release all sessions from a service group in resource
Perform the following steps to release all sessions from a service group in resource
manager.
1 Select the Resource Manager - Service Groups:Config page
2 Set the AdminState of the service group to Release and click Commit Changes.
3 Verify that the AdminState is set to OutOfService.
4 Verify that the sessions were released as follows.
1 Select the Resource Manager - Service Groups:Config page
2 Set the AdminState of the service group to Release and click Commit Changes.
3 Verify that the AdminState is set to OutOfService.
4 Verify that the sessions were released as follows.
a Monitor the EventLog tail.
b For a graphical view, select the Applications - SdvSm - Service
b For a graphical view, select the Applications - SdvSm - Service
Groups/Bandwidth page and click QamGraphic for the desired service
group.