Cisco Cisco StadiumVision Director Guide De Montage
© 2011 Cisco Systems, Inc. All rights reserved
Page 31 of 71
without a power switch, line voltages are present within the power supply when
the power cord is connected. Statement 4
the power cord is connected. Statement 4
Warning! Never install an AC power module and a DC power module in the
same chassis. Statement 1050
same chassis. Statement 1050
Warning! This unit might have more than one power supply connection. All
connections must be removed to de-energize the unit. Statement 1028
connections must be removed to de-energize the unit. Statement 1028
Connecting the Server AC Power
When connecting the SV Director Server to power, use the provided AC power
cord.
cord.
The AC power cord is considered the primary disconnect for the server and must
be readily accessible when installed. If the server power cord is not readily
accessible for disconnection, you must install an AC power disconnect for the
entire rack. This disconnect must be readily accessible, and it must be properly
labeled as the controlling power to the entire rack, not just to the server.
be readily accessible when installed. If the server power cord is not readily
accessible for disconnection, you must install an AC power disconnect for the
entire rack. This disconnect must be readily accessible, and it must be properly
labeled as the controlling power to the entire rack, not just to the server.
Power Connections
To connect the AC power cord to the SV Director Server:
Warning! This equipment must be grounded. Never defeat the ground conductor
or operate the equipment in the absence of a suitably installed ground conductor.
Contact the appropriate electrical inspection authority or an electrician if you are
uncertain that suitable grounding is available. Statement 1024
or operate the equipment in the absence of a suitably installed ground conductor.
Contact the appropriate electrical inspection authority or an electrician if you are
uncertain that suitable grounding is available. Statement 1024
2. Plug the AC power cord into the AC power input connector on the rear panel.
3. Connect the other end of the power cord to a power source at your site.
4. Repeat Steps 2 and 3 to connect the second AC power supply to power.
Caution! Do not power on the unit, yet.
5. Ground the rack.
To avoid the potential for an electrical shock, you must include a third wire
safety ground conductor with the rack installation. If the power cord is
plugged into an AC outlet that is part of the rack, you must provide proper
grounding for the rack itself. If the power cord is plugged into a wall outlet,
the safety ground conductor in the power cord provides proper grounding
only for the server. You must provide additional, proper grounding for the
rack.
safety ground conductor with the rack installation. If the power cord is
plugged into an AC outlet that is part of the rack, you must provide proper
grounding for the rack itself. If the power cord is plugged into a wall outlet,
the safety ground conductor in the power cord provides proper grounding
only for the server. You must provide additional, proper grounding for the
rack.
Connecting the Network Cable
By default, the SV Director Server has two Ethernet connectors, identified in
Figure 32. Connect only NIC 1 to the network using an RJ-45 connector.
Figure 32. Connect only NIC 1 to the network using an RJ-45 connector.