Cisco Cisco StadiumVision Mobile Streamer Manuel De Maintenance
© 2011 Cisco Systems, Inc. All rights reserved.
Page 53 of 103
Enabling Auto Registration and Auto-Provisioning
By default, the auto-registration and auto-provisioning settings in Cisco
StadiumVision Director are disabled. To use these features, you need to enable
them in the Management Dashboard as follows.
StadiumVision Director are disabled. To use these features, you need to enable
them in the Management Dashboard as follows.
1. Open the Management Dashboard and select Director Configuration > Auto
Registration Settings.
2. In the Cisco StadiumVision Director Configuration Property panel, set the values
to ‘true’ for Enable Auto Registration and Enable Auto Provisioning. Refer to
3. Click the save button.
Figure 41.
Enabling Auto Registration and Auto Provisioning in the Dashboard
Configuring the DMP Firmware Version
As part of auto-registration Cisco StadiumVision Director will upgrade a DMP that is
not already running the desired version. The desired version must be explicitly
configured by setting init.version and init.build in the same window where auto-
registration/provisioning was enabled in the previous section. Both init.version and
init.build have default settings. These may or may not match the desired version for
a given deployment, so they should be checked before DMP deployment starts so
they can be modified if needed.
not already running the desired version. The desired version must be explicitly
configured by setting init.version and init.build in the same window where auto-
registration/provisioning was enabled in the previous section. Both init.version and
init.build have default settings. These may or may not match the desired version for
a given deployment, so they should be checked before DMP deployment starts so
they can be modified if needed.
The latest DMP 4310 firmware can be downloaded from SW-Center on
. In order to deploy it to DMPs the firmware must first be uploaded to
CISCO STADIUMVISION DIRECTOR using the
DMP_and_TV_Controls
DMP_and_TV_Controls
àDMP_InstallàFirmwareàUpgrade option.