3com WX1200 3CRWX120695A Manuel D’Utilisation
298
C
HAPTER
13: C
ONFIGURING
U
SER
E
NCRYPTION
Changing the TKIP
Countermeasures
Timer Value
To change the TKIP countermeasures timer, see “Changing the TKIP
Countermeasures Timer Value” on page 298. The procedure is the same
for WPA and RSN.
Countermeasures Timer Value” on page 298. The procedure is the same
for WPA and RSN.
Enabling PSK
Authentication
To enable PSK authentication, see “Enabling PSK Authentication” on
page 298. The procedure is the same for WPA and RSN.
page 298. The procedure is the same for WPA and RSN.
Displaying RSN
Settings
To display the RSN settings in a service profile, use the following
command:
command:
display service-profile {name | ?}
The RSN settings appear at the bottom of the output.
RSN-related fields appear in the display service-profile output only
when RSN is enabled.
when RSN is enabled.
Assigning the Service
Profile to Radios and
Enabling the Radios
After you configure RSN settings in a service profile, you can map the
service profile to a radio profile, assign the radio profile to radios, and
enable the radios to activate the settings.
service profile to a radio profile, assign the radio profile to radios, and
enable the radios to activate the settings.
To map a service profile to a radio profile, use the following command:
set radio-profile name service-profile name
To assign a radio profile to radios and enable the radios, use the following
command:
command:
set ap port-list radio {1 | 2} radio-profile name
mode {enable | disable}
mode {enable | disable}
To map service profile rsn to radio profile bldg2, type the following
command:
command:
WX1200# set radio-profile blgd2 service-profile rsn
success: change accepted.
success: change accepted.