Aleratec 350103 Manuel D’Utilisation

www.aleratec.com

45

Power Requirements

115 - 230 VAC Switchable

Dimensions

(depth x width x height)

D: 285.8mm W: 187.3mm H: 171.5mm   

(7.38” x 6.75” x 11.25”)

Weight

3.36 Kilograms (7.4 Lbs.)

Note: Specifications subject to change without notice. 

If your 1:1 HDD Cruiser is not performing as expected, refer to the symptoms 

below, and follow the suggested corrective action. 

LCD Display

If the LCD display does not display any message and the 

backlight is not lit after powering on the 1:1 HDD Cruiser, 

check that the power cable is properly connected and that 

the ON/OFF switch is turned on.

Error Messages

While the system is performing an operation and the 

operation is manually terminated, an error message will 

be shown in the LCD display. This may lead to an failed 

operation and could cause the 1:1 HDD Cruiser to stop 

responding. If this happens, power the unit off, wait about 

ten (10) seconds, and then reapply power.

Hard Disk

If the 1:1 HDD Cruiser does not detect one of the hard 

disk drives, verify that the drive is properly seated in the 

drive bay.

Keypad Buttons

If pressing the keys on the front panel produces no 

response from the system, the 1:1 HDD Cruiser may still 

be busy with the previous operation. If the system idle, 

power the unit off, wait about ten (10) seconds, and then 

reapply power.

Firmware Update

The device can be updated to new versions of firmware 

via a DVD/CD drive. If unable to update the firmware, 

check that the firmware was downloaded correctly. A 

failed firmware upgrade may cause the 1:1 HDD Cruiser 

to become inoperable. If the system is working normally, 

do not attempt this operation. If the system is already 

experiencing problems, please contact Aleratec for repairs.

Startup/Shutdown

Do not power off the system while it is performing an 

operation. After a normal shutdown, wait about ten (10) 

seconds before reapplying power.