Siemens siemens network router mc35 Manuel D’Utilisation

MC35_SAT_01_v02.00

Page 26 of 65

11.01.2002

Write command

AT^SSTGI=16

This command is to be used upon receiving an unsolicited result code
^SSTN:16.

If the SIM Application attempts to set up a call it uses this response to inform the
TA of the call parameters.
The sequence of events is as follows:
1.  After the Remote-SAT notification 16 was issued the TA has to ask for the

command parameter via AT^SSTGI=16.

2.  If the SIM Application supplies no confirmation text or icon parameter, the

TA gives other information to the user, e.g. the telephone number. In this
case flow continues at step 4.

3.  If the SIM Application supplies a non empty confirmation text or icon

parameter, the TA uses only these to ask the user whether or not he wishes
to set up the call.

4.  If the user confirms to set up the call, AT^SSTR=16,0 shall be responded.
5.  If the user denies to set up the call, AT^SSTR=16,34 shall be responded.
6.  After confirmation phase the TA may present a dialling animation on the

screen until a mandatory parameter line

^SSTR: 16, <TermQualifier>, <TerminationCauseText>

is issued.

7.  If <TermQualifier> is not equal to 0 the dialling process did not perform

successfully.
If <TerminationCauseText> is not an empty string, this text has to be shown
to the user for an appropriate time, e.g. 2 seconds. The text contains
information regarding the dial termination cause, e.g. call barring through
Call Control by SIM mechanism.
<TerminationCauseText> is an empty string, the TA shall give an own
indication to the user.

8.  If <TermQualifier> is equal to 0, the dial process has been successfully

finished:
If <TerminationCauseText> is not an empty string, this text shall be used to
inform the user during the call setup.
If <TerminationCauseText> is an empty string, <callSetupText> and/or
<confirmationIconId> shall be used to inform the user during call setup.
However, if <callSetupText> contains no data, too, no indication shall be
shown.

9.  The TA shall give the user an opportunity to end an ongoing call, set up by

the Proactive Command. In this case the TA shall issue an ATH command
to the ME.

Response

^SSTGI: <cmdType>, <commandDetails>, <confirmationText>,
<calledNumber>, <callSetupText>, <confirmationIconQualifier>,
<confirmationIconId>, <callSetupIconQualifier>,<callSetupIconId> <CR> <LF>

Parameters

<cmdType>

16 – Proactive command ID, see Table 1

<commandDetails>

This byte is RFU.

<confirmationText>

String for user confirmation stage

<calledNumber>

String containing called number

<callSetupText>

String for call setup stage

<confirmationIconQualifier> Unsigned Integer, range 0 – 255, used as a bitfield.

bit 1:

0 = icon is self explanatory and replaces text