Tecumseh snow king oh358sa Manuel D’Utilisation

Page de 32
181-1275-14
4-Cycle • Snow King Engine
Page 19
5. Place approved recyclable oil container under oil drain 
plug, if present. See Figure 41 on page 18. Afterward, 
continue reading instructions below.
6. Remove oil drain plug, if present. 
7. Tip engine to position the oil flow, so it will drain from 
the lowest point on the engine (see equipment manu-
facturer’s instructions).
8. Drain oil into an approved recyclable oil container. 
 NOTE
Used oil must be disposed of at a proper collection center.
9. Install oil drain plug and tighten securely. 
10. Clean area around oil drain plug. See Figure 41 on 
page 18. Afterward, continue reading instructions 
below.
11. Remove oil fill cap/dipstick. See Figure 42.
12. Fill with recommended oil. See Figure 43. See  "III. Oil 
 NOTES
DO NOT overfill oil filler. Doing so may result in oil carry-
over to the equipment and cause malfunction or damage.
DO NOT allow oil level to fall below the “ADD” mark on oil 
fill cap/dipstick. Doing so may result in equipment 
malfunction or damage.
Contact your Authorized Tecumseh Servicing Dealer for 
Tecumseh Oil.
13. Wipe away any spilled oil.
14. Install oil fill cap/dipstick. Tighten securely.
 
15. Carefully disconnect spark plug wire from grounding 
post, if provided. See Figures 38 and 39 on page 18. 
See  "G. Avoid Accidental Starts" instructions on page 
2.
 Afterward, continue reading instructions below.
16. Carefully re-connect spark plug wire to spark plug. 
Figure 42. Oil Fill Cap/Dipstick Locations
Figure 43. Engine Oil Level
OH318SA/OH358SA
OH195SA/OH195SP
LH318SA/LH358SA
LH195SA/LH195SP
FULL
ADD
OK
Fill Between 
“FULL” and “ADD” 
Marks
File was named: 181-1275-14MY060105x.fm