FMI flame-max fvfm27nr Manuel D’Utilisation
www.fmiproducts.com
121353-01H
5
Figure 1 - Product Identification
Control
Knob
Knob
Piezo
Ignitor
Ignitor
Log Set
Base
Assembly
Assembly
Optional
Remote
Control
Remote
Control
Flame
Adjustment
Knob
Adjustment
Knob
Optional
Selector
Switch
Selector
Switch
PRODUCT IDENTIFICATION
UNPACkING
CAUTION: Do not remove the
data plates from the grate assem-
bly. The data plates contain impor-
tant product information warranty
and safety information.
1. Remove logs and heater base assembly
from carton. Note: Do not pick up heater
base assembly by the burner. This could
damage heater. Always handle base as-
sembly by grate.
base assembly by the burner. This could
damage heater. Always handle base as-
sembly by grate.
2. Remove all protective packaging applied
to logs and heater for shipment.
3. Check all items for any shipping damage.
If damaged, promptly inform dealer where
you bought heater.
you bought heater.
PRODUCT FEATURES
OpERATION
This heater is clean burning. It requires no
outside venting. There is no heat loss out a
vent or up a chimney. Heat is generated by
realistic, dancing yellow flames. This heater
is designed for vent-free operation with flue
damper closed. It has been tested and
approved to ANSI Z21.11.2 standard for
unvented heaters. State and local codes in
some areas prohibit the use of vent-free heat-
ers. This heater may also be operated as a
vented decorative product (ANSI Z21.60) by
opening flue damper (non-thermostat opera-
tion only).
outside venting. There is no heat loss out a
vent or up a chimney. Heat is generated by
realistic, dancing yellow flames. This heater
is designed for vent-free operation with flue
damper closed. It has been tested and
approved to ANSI Z21.11.2 standard for
unvented heaters. State and local codes in
some areas prohibit the use of vent-free heat-
ers. This heater may also be operated as a
vented decorative product (ANSI Z21.60) by
opening flue damper (non-thermostat opera-
tion only).
AppLICATION
These multisided logs are designed to be
equally beautiful when viewed from any angle.
They are designed specifically for use in see-
through, peninsula, and island fireboxes with
multiple openings. You may also install this
log heater in a standard firebox.
equally beautiful when viewed from any angle.
They are designed specifically for use in see-
through, peninsula, and island fireboxes with
multiple openings. You may also install this
log heater in a standard firebox.
SAFETY pILOT
This heater has a pilot with an Oxygen Deple-
tion Sensing (ODS) safety shutoff system. The
ODS/pilot is a required feature for vent-free
room heaters. The ODS/pilot shuts off the
heater if there is not enough fresh air.
tion Sensing (ODS) safety shutoff system. The
ODS/pilot is a required feature for vent-free
room heaters. The ODS/pilot shuts off the
heater if there is not enough fresh air.
pIEzO IGNITION SYSTEM
This heater has a piezo ignitor. This system
requires no matches, batteries, or other
sources to light heater.
requires no matches, batteries, or other
sources to light heater.
LOCAL CODES
Install and use heater with care. Follow all
local codes. In the absence of local codes,
use the latest edition of The National Fuel
Gas Code, ANSI Z223.1/NFPA 54*.
*Available from:
local codes. In the absence of local codes,
use the latest edition of The National Fuel
Gas Code, ANSI Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
Note: Where listed vented decorative logs
are required, thermostat operation is not
permitted.
are required, thermostat operation is not
permitted.
State of Massachusetts: The installation
must be made by a licensed plumber or
gas fitter in the Commonwealth of Mas-
sachusetts.
Sellers of unvented propane or natural
Sellers of unvented propane or natural
gas-fired supplemental room heaters shall
provide to each purchaser a copy of 527
CMR 30 upon sale of the unit.
Vent-free gas products are prohibited for
Vent-free gas products are prohibited for
bedroom and bathroom installation in the
Commonwealth of Massachusetts.