Cisco 2811 ROUTER 2FE 1NME 4HWIC 2PVDM 2AIM IP BASE WITH A/C POWER SUPPLY Guide De Spécification

Installing and Upgrading Internal Modules in Cisco 2800 Series Routers

OL-5792-04

Replacing the Power Supply

Step 1

Insert the AC-input power supply into the chassis from the front.

Step 2

Install the two power supply retaining screws. Torque to 8 to10 in-lbf (0.9 to 1.1 N-m). See

Step 3

Connect the primary power supply cable to the power supply. Make sure that the locking feature on the
power supply end snaps into position. See

Figure 46

Primary Power Cable Connection in a Cisco 2821 or Cisco 2851 Router

Step 4

Install the bezel onto the front of the chassis as follows:

Engage the plastic tabs of the bezel into the slots in the chassis.

Slide the bezel until it is centered and tight against the chassis.

Step 5

If you are finished installing modules, install the cover on the router. See the

Power supply

Primary power cable connector

103705