Comp X Security Products Inc 421860 Manuel D’Utilisation
8.
Plug the garage door opener receiver into the selected
power outlet.
power outlet.
9.
Plug the power cord from the garage door drive unit into
the power outlet.
the power outlet.
10. Press the wall mounted garage door opener button to set
the button operation.
Program the Receiver and Transmitter
The receiver must be programmed to receive the transmitter
frequency. This process may require two people depending
on how far apart the receiver and transmitter are during the
programming process.
frequency. This process may require two people depending
on how far apart the receiver and transmitter are during the
programming process.
1.
Check that a red light is visible on the front of the Harley-
Davidson garage door opener receiver, indicating power
to the receiver.
Davidson garage door opener receiver, indicating power
to the receiver.
2.
See Figure 72. Press and hold the Set button (3) on the
Harley-Davidson garage door opener receiver. The LED
(2) blinks continuously while the Set button is pressed.
Harley-Davidson garage door opener receiver. The LED
(2) blinks continuously while the Set button is pressed.
3.
Set the motorcycle ignition switch to IGN. Switch the
headlamp beam switch using one of these sequences.
headlamp beam switch using one of these sequences.
When the receiver receives a signal from the transmitter,
the LED on the transmitter turns off.
the LED on the transmitter turns off.
a.
Starting from Low beam, switch High, then Low.
b.
Starting from High beam, switch Low, then High.
4.
Release the Set button on the receiver.
NOTE
Clear all obstructions away from between the transmitter and
receiver before testing the operation of the garage door opener.
receiver before testing the operation of the garage door opener.
5.
Test the garage door opener, high beam, and low beam
headlamp operation.
headlamp operation.
NOTE
When the transmitter is activated by toggling the headlamp
switch, the red LED on the transmitter illuminates for one
second to indicate that the transmitter is functioning correctly.
switch, the red LED on the transmitter illuminates for one
second to indicate that the transmitter is functioning correctly.
6.
Set the motorcycle ignition switch to OFF.
Maintenance and Lubrication 189