Exegin Technologies Limited Q53R6 Manuel D’Utilisation
48
Q53 Installation and Configuration Guide © Exegin Technologies Limited, 2013
8. Using HTML Pages to Configure the Q53
ZigBee Forms
ZigBee Forms
Figure 18—ZigBee Configuration Form
Radio
Channels
Channels
Radio buttons are provided to select the desired channel for the 2.4 GHz radio.
Default: No channels selected.
ZigBee
Coordinator
Coordinator
By default, the Q53 acts only as a ZigBee Bridge Device (ZBD) to bridge ZigBee
network messages over TCP/IP. However, the Q53 is also capable of acting as ZigBee
Coordinator for the local ZigBee PAN. A check box is provided to enable the Q53 to act
as ZigBee Coordinator for the local PAN. If this functionality is selected.
network messages over TCP/IP. However, the Q53 is also capable of acting as ZigBee
Coordinator for the local ZigBee PAN. A check box is provided to enable the Q53 to act
as ZigBee Coordinator for the local PAN. If this functionality is selected.
Default: ZigBee Router functionality is selected.
Saving
Configuration
Changes
Configuration
Changes
Any changes on this page will be saved only when the ’Submit’ button is clicked. In
order for the new values to actually take effect, the Q53 must be re-started.
order for the new values to actually take effect, the Q53 must be re-started.
To erase all changes, click the ’Revert’ button.
ZigBee Status Page
The ZigBee Status page is shown in
. Use this page to troubleshoot
ZigBee-related problems. Network status indicators are recorded in this page; there are
no configuration settings. The page refreshes every minute. The Radio status, ZigBee
Network Neightbour table, and ZigBee Network Routing table are displayed.
no configuration settings. The page refreshes every minute. The Radio status, ZigBee
Network Neightbour table, and ZigBee Network Routing table are displayed.