Godex International Co. Ltd. 6PDL7 Manuel D’Utilisation
4. Accessory
4-1. Cutter Installation
1 Cutter
Module
2 Lock*2
3 Screw*2
3 Screw*2
【
Note
】
To install the Cutter Module, please power
off the printer first.
off the printer first.
1
2
3
1.
Open the Top Cover and unscrew two
screws in the front to remove the
Tear-off bar.
screws in the front to remove the
Tear-off bar.
2.
Hold the Cutter Module and secure
with screws to install it on printer.
with screws to install it on printer.
3.
Plug the cutter cable into the cutter
connector.
connector.
4.
Tie the cables with secure lock, and
stick the lock on the Bottom Plate.
stick the lock on the Bottom Plate.
5.
Load the label to the printer. Close the
Top Cover to complete the cutter
installation.
Top Cover to complete the cutter
installation.
【
Note1
】
Make sure the cutter function is
set to activate on printer setting.
【
Note2
】
The label / paper used for cutting
is suggested to be at least 40mm in height.
DuraLabel 7000 User’s Manual
30