CyberPower RMCARD202 Manuel D’Utilisation

 

 

 PowerPanel™ Business Edition 

 

 

 

 

 

 

 

 

 

 

 

       44    

may cause this event. Reduce some UPS load or set a more accurate shutdown time could avoid this 

event occurrence.  

z  Enters bypass mode - Entering bypass mode, battery power will no longer be provided.   

z  Utility power failure - Utility power failure, battery power will be supplied. 

z  Remaining runtime will be exhausted - Remaining runtime will be exhausted and can't afford a 

 

When the UPS switches to battery mode due to power event, the battery power will be supplied to Agent 

computer and all Client computers in order to shutdown completely. When the battery power 

consumption continues, the UPS remaining runtime will be exhausted. Agent and all Client computers 

should start the shutdown procedure. 

z  Battery test is processing - Process battery test to verify that battery power can be provided normally.  

z  Output voltage is being boosted - Output voltage is being boosted from a lower level.  

The UPS is receiving utility power with low voltage and raising the voltage to a proper level for operating 

the connected equipment.  

z  Output voltage is being bucked - Output voltage is being bucked from a higher level.  

The UPS is receiving utility power with high voltage and is lowering the voltage to a proper level for 

operating the connected equipment.  

z  Calibration initiated - Calibration was initiated, the battery runtime will be evaluated.  

z  A schedule has initiated - A schedule has initiated, the system could be shutdown. 

z 

 

z 

Shutdown initiated - Shutdown process initiated. 

 

A shutdown process has initiated, and the system will shutdown or hibernate. 

 

z  The output power is going to stop soon - Output power will stop due to power event or user demand. 

When an UPS or a PDU is about to stop supplying the power to a Client computer, the Client will be 

notified. The Client will shut down the hosted computer.  

z  Cannot establish network communication with Power Device - The communication with Power 

Device has been lost.  

The Client cannot establish communication with the UPS or PDU on the network or established 

communication has been interrupted.  

z  Network communication lost with UPS in a power event - The communication with UPS has been 

lost after a power event occurred.  

When the utility power becomes abnormal and the UPS is using the battery to supply power, loss of 

network communication between the Client and the UPS causes the Client to generate a critical priority 

event because it cannot respond to changes in the status of utility and battery power.